It doesn't look too clever to be honest, bit grubby. No idea what it says on it. I will have a look when it arrives. I knew it wasn't Mosfet but from my understanding the standard R1/R6 ones work fine, and not too hard to wire up.
Have a good read through the link above > "MOSFET Regulator/Rectifiers - The Why & The How" that describes the difference between Shunt and Mosfet R/Rs, the advantages of Mosfet and lists what models and years are suitable to be used.
The one youve bought from fleabay is too early to be a MOSFET.
It may be that your whole purpose in life is simply to serve as a warning to others.
adewhitmarsh wrote:I can supply a pair of manual ccts with tracked postage for £46.00.pm me for more details & picture or find me on the forum under manual cct suppliers.
Adie, I want some of your CCTs mate, but I'm new so can't PM you. How do I get in touch mate?
I'm just off from the Pentagon island at the minute. Might be moving at some point but normally at places like Robin Hood Harley, CMC, Chesterfield if I get bored etc and now this thing is up and running i might try and get to MFN a bit more and the vic in Coalville. Would go Matlock a fair bit but I've heard coppers are pulling everyone over for anything so the sheer noise of this thing wont go down too well.
Basically - going to ride when I can. As much as possible.
Ade kindly messaged me yesterday as I couldn't message him either due to being new. Made it easy for me to get hold of some and looking forward to when the CCTs arrive
Honda VTR 1000F 1997 Black
Arrow Exhausts
Maxton Rear Suspension
Renthal Grips
R&G Bar Ends and protectors
ASV levers
Blackbird Stand
Wanted
Manual CCT's (bought but need to be fitted)
Mosfet Reg/Rec
Metalmad18 wrote:I'm just off from the Pentagon island at the minute. Might be moving at some point but normally at places like Robin Hood Harley, CMC, Chesterfield if I get bored etc and now this thing is up and running i might try and get to MFN a bit more and the vic in Coalville. Would go Matlock a fair bit but I've heard coppers are pulling everyone over for anything so the sheer noise of this thing wont go down too well.
Basically - going to ride when I can. As much as possible.
Ade kindly messaged me yesterday as I couldn't message him either due to being new. Made it easy for me to get hold of some and looking forward to when the CCTs arrive
Sound, I'm in Alvaston, but work over Shepshed and have a lot to do with the various quarries, so know a fair few lads over that way. Did my test in Coalville with Able Rider.
Have a good read through the link above > "MOSFET Regulator/Rectifiers - The Why & The How" that describes the difference between Shunt and Mosfet R/Rs, the advantages of Mosfet and lists what models and years are suitable to be used.
The one youve bought from fleabay is too early to be a MOSFET.
Now the daunting task of actually fitting them. I can't help but think that this can go very wrong and I'm very nervous about doing it alone. Any tips, or experienced people about to lend a hand? or show me the way. there are some good reads on this site about it but I can't help but feel there is still margin for error with quite bad circumstances. maybe overnervousness or apprehension but i'm better off making sure right?
Honda VTR 1000F 1997 Black
Arrow Exhausts
Maxton Rear Suspension
Renthal Grips
R&G Bar Ends and protectors
ASV levers
Blackbird Stand
Wanted
Manual CCT's (bought but need to be fitted)
Mosfet Reg/Rec