freeridenick wrote: ↑Wed Feb 08, 2023 8:40 pm
What have folks used to glue the VTR rubber seal to the CBR coil body? I never bothered but it does wiggle a bit more than I'd like. It would be better to keep water away from the plug too.
I used left over "special silicone" that came with my carbon adi case covers and it has held up very well
Loud pipes don't save lives, knowing how to ride your bike will save your life.
Yep!
High temp silicone all day long. Unless the gap is too sloppy between the surfaces. Then I would probably look for a bit of silicon sheet ( like what you can use for putting hot plates on) cut it to size and then stick it in place with high temp silicon
Sent from my iPhone using Tapatalk
My new ride is a bit of a Howler and I love to make her Squeal
