VTR1000.ORG

Thanks thanks thanks!!!!

Thanks MacV2 for the reply! But...sorry, i'm even more confused...be patient with me... Some people say a zip tie around the piston is the way to go... I suppose you mean, AFTER removing the cover, in order to prevent the piston to jump out. Right? Then I just remove the lever, simple & never ha...

Hello everybody, i'm planning to change the transmission kit (chain + F/R sprockets) and looking on the workshop manual i find out this procedure: "Remove the following: -three bolts, clutch slave cylinder, dowel pins and gasket NOTE: • Do not disconnect the clutch hose. • To keep slave cylinde...

Hi guys, on my "new" old-lemon the engine stops quite frequently when idling, both running or when i stop. I had to set the idle to around 1800/1900 rpm to minimize the problem. (thet still happens sometimes). Also, if i accelerate, the bike revs up nicely but when i leave the gas the engi...

Thanks a lot!

I was worried that the smaller filter could cause some damage.

So, for the next oil change i will just pick up the cheaper one!

Thanks again

Hi guys, i'm a bit confused about which is the right oil filter for my 2001 VTR. Looking at the original Honda spare parts, making a research from my VIN it seems that the standard one cod. 15410-MM9-013 is no more available and it's been replaced by the cod. 15410-MCJ-505. I searched them on intern...

Spare parts collected!

Now, i want to ride at least 1k km with original handlebars (if i can manage the pain!) before proceding with the swap.

In the meanwhile i want to find a way in order to avoid cutting the farings.

Have a look at Roads exhaust, really well made, cheap and with omologation (at least here in Italy) https://www.roadsitalia.com/it/1400-honda-vtr-1000-f-roadsitalia They are on my to-do list with a Dyno stage 1, just after the CCT stop mod and handlebars raising. For the V2 i reccomend not to go wit...

Hi guys, i just purchased a my'01 VTR and i would like to do the VFR handlebars swap but...there's something strange... :confused How can you fit them?! They use different locking position. I also have a my'98 VFR and theese are some pictures of them. https://i.postimg.cc/hXvnymWF/IMG-20220319-18295...

Ok, i can see the point of protection...

Maybe i could try to wrap the hugger (i want to save the color...who knows...) and give it a chance....

Hi guys, I've just purchased an old VTR in stock condition, but the ex-owner gave me also a couple of fiberglass additional parts: a lower cowl and a rear fender. Now...the point is...why should i fit theese parts on the bike?! I find the rear fender quite ugly (maybe black it would had been accepta...

Just arrived at home! Unlikely during this night i got high temperature ad a bad flou... I think i will have to wait some days before squizing the lemon! [emoji16] https://uploads.tapatalk-cdn.com/20220312/40a9b39fc738bf456d6425aab17a93c5.jpg https://uploads.tapatalk-cdn.com/20220312/c70f9a1cef8933d...

Hello everybody! I'm Def@st from Modena, Italy, and tomorrow i'm going to buy a 2001 yellow VTR 1000 F with 41k km. The bike is completely original (with hystorical certification) except for the front fork springs that are progressive HyperPro and front stainless steel brake lines. I try to introduc...