VTR1000.ORG

Hi, as I read this site and sometimes write, I show my bike here:

Forks: Racetech springs 0.875, Racetech compression valves C36, 130 mm air gap, Motorex 5W oil, tapered rebound rods
Coerce fork brace
Rear Shock: from Jamie Daugherty, modified CBR600F4 with Racetech internals, 5mm add height
CBR954RR calipers and master cylinder, Ferodo STAC pads
Lightened flywheel
Arrow full Ti exhaust
FactoryPro Ti needles, 180+182 main jets, 48 pilots
Two oem long stacks
Hiflo paper filter, Burnie Morgan mod
520 EK MVXZ chain, Renthal sprockets, 16/43 gearing
LifePo4 battery pack
APE manual CCTs
Lucas braided hoses
TriblePerformance steering damper
CBR600RR ignition coils, Denso IX27B plugs
CBR1000RR sidestand
Pyramid Plastics rear hugger
F.Fabbri db screen

Looking good Stephan. Did you do the artwork in the background? You only need to save up for a respray in a decent colour to finish the bike off!!!!

Kev L wrote:Looking good Stephan. Did you do the artwork in the background? You only need to save up for a respray in a decent colour to finish the bike off!!!!

That's what I thought!



Lovely looking bike, and nice pictures too.
That's a comprehensive list of mods you've done, I bet she goes as well as she looks

Very nice mate.

a very nice well sorted bike buddy

a good looking fast red un! but your house could do with a lick of paint! oh and some glass in the windows!!

sorry, I haven´t cleaned up the house this week ...

and thanks guys

nice bike,like very much

Very nice bike. Why the CBR sidestand?

Interesting backdrop you have chosen for the pics. I have to disagree with Murv and say The pictures are not the best but are OK. You are supposed to be showing off the bike not the background

(:-})

The CBR stand is slightly longer so makes the bike stand more upright. Particularly useful if the ride height has been altered making the bike lean over further.

cybercarl wrote:Very nice bike. Why the CBR sidestand?

Interesting backdrop you have chosen for the pics. I have to disagree with Murv and say The pictures are not the best but are OK. You are supposed to be showing off the bike not the background

(:-})

As Kev wrote, bike is more upright now after rear raised by 5 mm. I agree pictures are not the best, it´s taken by mobile and I am not good photographer neither :-)

This is how it was with original stand

I was only teasing about the pics mate. That is some serious lean. I have noticed these bikes tend to lean a lot especially on a slightly inclined surface. I'm always careful putting the bike on the sidestand and sometimes it's a bit, Oooo Argh Woe, then reposition. 9 times out of 10 it's safe but just looks dodgy and doesn't feel comfortable leaning it over that far.

(:-})

Any particular year for the 1000RR sidestand or do they all fit?

Will look at doing this mod as my butt is 6mm higher and the bike leans waaaay over!

Jester666: CBR1000RR 04-07. You need to change only the side stick. Sensor and bracket held in place.

Stephan wrote:Jester666: CBR1000RR 04-07. You need to change only the side stick. Sensor and bracket held in place.

Excellent. Thank you