VTR1000.ORG

Richard wrote: ↑Sun Dec 29, 2019 5:59 pm Dropped some ultra low rise bars on to mine. So far so good. Not actually ridden it yet but here's hoping !!

fabiostar wrote: ↑Sat Dec 28, 2019 10:05 pm Iv decided new bikes do everything better, stop ,go,handle,blah blah blah but i dont like them as much, they lack sole..

thats not to say the first chance i get im gona get the DD out and have a ball of a time.

Stephan wrote: ↑Mon Dec 30, 2019 12:00 pm

fabiostar wrote: ↑Sat Dec 28, 2019 10:05 pm Iv decided new bikes do everything better, stop ,go,handle,blah blah blah but i dont like them as much, they lack sole..

thats not to say the first chance i get im gona get the DD out and have a ball of a time.

That soul was present here for quite a long time and almost burnt Glad to see it running.

MacV2 wrote: ↑Tue Dec 24, 2019 6:24 pm Rode it to Area 51 & was analy probed...

Well part of that statement isn't really true...it wasn't Area 51 it was an NHS centre...

Bowel Cancer screening...

So after that I went & splashed 600 squid on new boots & a jacket...I've gone all gortex for the jacket...I drew a line on spending £300 on a pair of matching trews tho !

I will be off out on the bike tomorrow... Not back into work until 2nd Jan...I may be in the cave for some time...

MaroonMachine wrote: ↑Mon Dec 30, 2019 5:51 pm Went for a ride down Poole,and found a lovely spot at Sandbanks.What a glorious sunny day!

alanfjones1411 wrote: ↑Tue Dec 31, 2019 7:06 pm Don't know anything about the bodged wires as I never had the fairing off.As for the belly pan it may have been made by Harris's as I know they done the 916 front end and exhaust along with other works.

AMCQ46 wrote:Well big bird has now stolen the battery off the storm and pushed the Ducati off the work bench.



Heated seat and grips, electronic suspension, tyre pressure monitoring and massive tank range. Wtf!


Sent from my iPhone using Tapatalk

MacV2 wrote: ↑Tue Dec 31, 2019 4:30 pm Changed the oil on Red 633...

This meant removing the bottom half of the fairing... It has a hole to check the oil but needs to be off to do the oil change.

Whatever it is its not like any I have seen before. The two bottom std fairing mount bolts ( std ones...) & one bracket on the R/H side held on with a Dzus Fastner. The bracket bolts to the bolt from the engine plate.



It's one peice... It deffinatly is not fiberglass as its really light.

In fact it weighs...



& it's a waffer thin...



Carbon maybe..? Took the fairing off & found the first bodge... The side light std connector is gone & just has some wires spliced in with bare connectors for the two pins. Strange.

popkat wrote: ↑Fri Jan 03, 2020 10:53 pm
It's a harris belly pan, which I may have been a replica of the sharkskins one (from the usa), I put one on my first storm back in y2k, it's still on it as I know where the bike is but it's not been used in years. mine didn't have a cutout for the downpipe so yours may have been modified for that at some time. they are the only type I've ever seen with the dzus fastner. Very high quality and very light weight.

Material is woven fibreglass, all the Harris fairings were back then, had them on my 600cc race bikes too, again very light and very strong compared to other fibreglass options