exact quantity of oil/level window

[mattycoops43]

If it leaks, you didn't do it up enough!



This thread is getting daft!

[VTRDark]

3 pages on oil and filter change

(:-})

[Theodio]

Sorry guys!!

I found 28 euros per 4 lts Motul or Bel-ray!!

[budd]

Sorry guys!!

I found 28 euros per 4 lts Motul or Bel-ray!!

Motul

[nt1980]

That's a nice pair of grips carl

[VTRDark]

Their not the exact ones I have. Mine are about twice as big as that and can easily grip around an oil filter or even a clutch basket just about. I think they are called water pump pliers.

(:-})

[Jamoi]

Hi guys, can someone please tell me 6 different ways to tie my shoelaces please?

[MacV2]

Hi guys, can someone please tell me 6 different ways to tie my shoelaces please?

That would be a waste of time, your Mum told me that you can just about manage the Velcro fasteners Jamie ?

[Jamoi]

Oi you get back to your "wrist exercises"!

[nt1980]

Their not the exact ones I have. Mine are about twice as big as that and can easily grip around an oil filter or even a clutch basket just about. I think they are called water pump pliers.

(:-})

I no the ones you mean i have two 6 inch pairs about ton a piece i use for pvcu unions they all so replace the 16 oz hammer

[VTRDark]

they all so replace the 16 oz hammer

I've done that, turned them on the side edge and hammered gently.

Actually last time I used them in a hammering situation was to put the lower fork bearing on. I turned them on their side, not the edge this time but the flat faced part. Opened jaw up and around the old bearing, not clamping, jaws resting on both sides of the old bearing, which was sitting on top of the new one. I have then used a hammer against the largest side/area (grip side) of the grips to tap the bearing down while moving the grips around the circumstance every now and again so it was tapping the bearing down as evenly and consistently as I could under the circumstances.

It was a case of where needs be, and after that I said to myself I really must buy a proper tool for this job or get a bit of pipe The right tool for the job makes life so much easier but ingenuity helps too.

(:-})

[MacV2]

Oi you get back to your "wrist exercises"!

What tying shoelaces... Your just jealous 'coz you can't .

[darkember]

Why the hell is this thread still going

[VTRDark]

We've broken off into splinter groups. That will teach Theo to start an oil thread oh, hold, don't all threads end up like this.

(:-})

[darkember]

We've broken off into splinter groups. That will teach Theo to start an oil thread oh, hold, don't all threads end up like this.

(:-})

No that's lloydies & Virts threads