any of you boys got a scrap/bent/ugly/shitty clipon sitting about. must have the bar end still in it tho..
im looking one to measure/copy for making up bar ends?... once i have the bar to make them out of il send you a nice set of shiny bar ends for your trouble..
scrap clipon
Moderator: VTRDark
scrap clipon
the older i get,the faster i was
- freeridenick
- Posts: 1591
- Joined: Fri May 23, 2014 1:30 pm
- Location: Derbyshire
Re: scrap clipon
Got two spare sets that are straight.
Re: scrap clipon
il see if anybody has one bent one or an odd one.. dont really wana split a set up on you. its so i have a bar end and a bar sitting infront of me to get dimensions and bar end fit correct.if that makes sense?. iv every type of bar except a standard one sitting about
the older i get,the faster i was
- freeridenick
- Posts: 1591
- Joined: Fri May 23, 2014 1:30 pm
- Location: Derbyshire
Re: scrap clipon
OK. I only really need one spare set but Sods Law would say I'll drop it on the same side twice as soon as I get rid of one on that side.
If you don't get sorted I'll send you one with a SAE so I can get it back
If you don't get sorted I'll send you one with a SAE so I can get it back
Re: scrap clipon
Rob I can lend you a clip on have a few TBH...
I'll dig one out & send it to you tommorow.
Any prefrence left or right ?
I'll dig one out & send it to you tommorow.
Any prefrence left or right ?
Making up since 2007, sometimes it's true...Honest...
Re: scrap clipon
starbar mac... either side will do. i can then make a dummy bar and get a few sets of bar ends put together..i will send you over a nice shiny set back with it..
the older i get,the faster i was