Hey guys,
Maybe this is a stupid question, but when putting the engine case halves together using the gasket sealer, do I have to put it back together as soon as possible while the sealer is wet or is it ok to let it dry a bit first and then bolt down?
Cheers
Case halves
-
- Posts: 177
- Joined: Wed Jun 08, 2005 9:07 am
- Location: staffs
I've used the blue stuff before...should let it go slightly tacky then put the 2 bits together.
Finally when it drives turns to a rubber. Also used the black stuff....horrible it is. Once you've put it on you have to put together straight away. Dries like tar and is a nightmare to get off your hands. Best to wear rubber gloves.
Finally when it drives turns to a rubber. Also used the black stuff....horrible it is. Once you've put it on you have to put together straight away. Dries like tar and is a nightmare to get off your hands. Best to wear rubber gloves.
Jurgs