How to fit stick coils

Where all the workshop knowledge lives together.
User avatar
lloydie
Posts: 20920
Joined: Mon Jan 17, 2011 11:16 pm
Location: In the garage somewhere in Coventry

How to fit stick coils

Post by lloydie »

You will need stick coils from a cbr600rr 3-6
And your old coil plugs
Wire cutter
Insolation tap
Soldering iron and solder

Image
Cut the plug of the vtr coil but leave the wires long enough to solder to the cbr's sub loom .
Now cut the cbr's sub loom so you have two wires per plug .
Then solder the cbr's plug to the vtr
Plug
the total length should be rear 37cm and the front 50cm.
those are a bit longer than needed, but better too long than too short
I'd only add that it would be a good idea to have enough slack in the loom wires so that the wires can hang down below the entry point. This will allow condensation or r ain to drip off the wires rather than run down them into the cable entry holes.
Doesn't seem to be affected by rain fitted as is, but it seems a relatively simple safeguard, just in case.
Image
Green vtr to the black cbr's that's the earth
The other colour is the live
Then tape up
Image
Now fit to the vtr's loom
When you have done that its time to test fit the coil and you will find it will wobble
The best way to stop this is to do what amcq46 did .
Cut up the vtr's plug cap and glue in place , Image
Image
Image
Now start it up and enjoy as you will now have 2bhp more :clap:


Can't ride but it don't stop me trying



Can't ride but it don't stop me trying
User avatar
seb421
Posts: 4840
Joined: Fri Mar 06, 2009 1:06 am
Location: Bolton Lancs

Re: How to fit stick coils

Post by seb421 »

Now start it up and enjoy as you will now have 2bhp more :clap:

Really?

what's the advantages / any disadvantage using this?
ヨシムラ

MOT - 10/04/2015
TAX - 30/11/14
INSURANCE - MCE - Expires 12/04/2015 (Midnight)
ACCIDENT CALL - 0871 2227910
RAC - 0800 1977830 - 03_MCECAB90013033
rob...
Posts: 322
Joined: Sun Oct 23, 2011 12:08 pm

Re: How to fit stick coils

Post by rob... »

seb421 wrote:
Really?
yep.

dyno proven. details on the superhawk forum, i believe.
seb421 wrote:what's the advantages
2bhp for about half an hour of your time.
seb421 wrote:any disadvantage using this?
you have to buy the stick coils and loom, use 2 of them, sell the other 2, sell your std coils, and spend half an hour with some spanners and a soldering iron.

so no, none. :D :D
When subjected to an electrical voltage of at least 50 volts, a cat's tail always points toward the north.
User avatar
Kev L
Posts: 11209
Joined: Tue Aug 24, 2010 9:57 pm
Location: Hertford, England

Re: How to fit stick coils

Post by Kev L »

Seb I have two CBR600RR stick coils & the loom for them for £25 if you are interested.
Carpe diem, quam minimum credula postero
F3, 954 USD front, K Tech springs, Braced swinger, Penske shock, Six spoke Mockesini wheels, Harris rearsets, QaT, Flywheel diet!, A&L stacks, stick coils, K&N, FP Ti jets, lashings of Ti & CF
tony.mon
Posts: 15943
Joined: Wed Jul 25, 2007 10:46 pm
Location: Norf Kent

Re: How to fit stick coils

Post by tony.mon »

A small note of realism needed here, this mod as compared to the standard setup can lead to +2hp, but that's only if your standard setup has small inefficiencies, HT leads not as good as they were, but also the chances are that while you're there you'll have fitted new plugs as well......

Having said that, I've done the mod, seems fine.

You just don't get HT lead and connection losses, so a better spark.
It's not falling off, it's an upgrade opportunity.
User avatar
seb421
Posts: 4840
Joined: Fri Mar 06, 2009 1:06 am
Location: Bolton Lancs

Re: How to fit stick coils

Post by seb421 »

Thanks for the info tony, that was more what i was looking for.

I was wondering how it would get more power as it would surely be igniting the fuel / sparking at the same timing as the original HT leads wouldn't it?

if you use the same spark-plug's its just going to be the same as before isn't it?

unless you advance the timing I dont see how it would bring about a 2bhp increase?



Thanks for the offer Kev, at the moment its not something I feel competent at doing ive never soldered anything before so wouldn't want to wombles up a critical part.

Does any one do the kits ready to install?
ヨシムラ

MOT - 10/04/2015
TAX - 30/11/14
INSURANCE - MCE - Expires 12/04/2015 (Midnight)
ACCIDENT CALL - 0871 2227910
RAC - 0800 1977830 - 03_MCECAB90013033
rob...
Posts: 322
Joined: Sun Oct 23, 2011 12:08 pm

Re: How to fit stick coils

Post by rob... »

seb421 wrote:Thanks for the info tony, that was more what i was looking for.

I was wondering how it would get more power as it would surely be igniting the fuel / sparking at the same timing as the original HT leads wouldn't it?

if you use the same spark-plug's its just going to be the same as before isn't it?

unless you advance the timing I dont see how it would bring about a 2bhp increase?

that's pretty much exactly what i thought, but the bloke on the 'superhawk' forum dynoed his bike, fitted a set, got 2bhp more, took them off, re-dynoed it, and lost the 2bhp.
i'll be doing exactly that when mine goes back together, so we'll see.......
When subjected to an electrical voltage of at least 50 volts, a cat's tail always points toward the north.
User avatar
Stratman
Posts: 2656
Joined: Mon Dec 01, 2003 10:55 pm
Location: Norwich
Contact:

Re: How to fit stick coils

Post by Stratman »

Am I right in assuming that you can't detach the HT lead from the standard coils to change the lead for new stuff?
Two bikes, still only four cylinders!

Image
tony.mon
Posts: 15943
Joined: Wed Jul 25, 2007 10:46 pm
Location: Norf Kent

Re: How to fit stick coils

Post by tony.mon »

Stratman wrote:Am I right in assuming that you can't detach the HT lead from the standard coils to change the lead for new stuff?
The stick coils don't have HT leads at all.
The low tension leads clip straight on to the top of the stick coil, which sits like a 15mm diameter tube on top of the plugs.
It's not falling off, it's an upgrade opportunity.
User avatar
Stratman
Posts: 2656
Joined: Mon Dec 01, 2003 10:55 pm
Location: Norwich
Contact:

Re: How to fit stick coils

Post by Stratman »

Sorry Tony, I didn't make myself clear. Forgetting the stick coild for a moment, if I wanted to replace the HT leads on the existing coils - I don't think it is possible to disconnect the HT lead from the actual coil?
Two bikes, still only four cylinders!

Image
User avatar
KarlosVTR
Posts: 473
Joined: Sat Dec 30, 2006 6:21 pm
Location: Derby

Re: How to fit stick coils

Post by KarlosVTR »

it should be.

a clip on the coil and a tug on the lead. its like a bear claw type affair if i remember. just had to do it to my mates thunderace and my brothers zx7
User avatar
aces-high
Posts: 106
Joined: Sat Jan 29, 2011 11:52 pm
Location: Glossop

Re: How to fit stick coils

Post by aces-high »

Unscrew HT leads from both ends, The plug cap and coil both have spikes that the centre of the HT lead screw onto. That's why sometimes if your getting a weak spark it can just be a bad/rusty connection and just needs cutting back.
User avatar
darrenmartin
Posts: 416
Joined: Mon Apr 02, 2012 5:17 am
Location: Norfolk UK

Re: How to fit stick coils

Post by darrenmartin »

Hi guys any one got 2 stick coils for me to f*ck up when i try fitting them :lol:
Like Riding Thunder and Lightning
User avatar
seb421
Posts: 4840
Joined: Fri Mar 06, 2009 1:06 am
Location: Bolton Lancs

Re: How to fit stick coils

Post by seb421 »

im supposed to be buying 4 off someone on here for an agreed price, but cant remember who it was, as i only need two you can have the other two off me for cost
ヨシムラ

MOT - 10/04/2015
TAX - 30/11/14
INSURANCE - MCE - Expires 12/04/2015 (Midnight)
ACCIDENT CALL - 0871 2227910
RAC - 0800 1977830 - 03_MCECAB90013033
User avatar
darrenmartin
Posts: 416
Joined: Mon Apr 02, 2012 5:17 am
Location: Norfolk UK

Re: How to fit stick coils

Post by darrenmartin »

I dont care what the others say about you seb (and it aint kind :sad2 ) i think your alright :wink: and if and when you get em id be glad to fleese you, sorry i mean buy the other 2 from you :thumbup: Cheers m8
Last edited by darrenmartin on Sun Apr 08, 2012 8:14 pm, edited 1 time in total.
Like Riding Thunder and Lightning
Post Reply