VTR1000.ORG

Enjoy the Pan mate. Nothing worse than being in pain so lets hope the Pan gives you a comfy ride.

Ive ridden a couple and they get along well.

Im a Customer Service team leader, tech support for all the bicycle brands we sell. Mavic specialist.

Im also that guy, Health and Safety chairman.

Hmmm, can I harden the cams at home?

tony.mon wrote:There's no point leaving them unhardened, as the lobes wear and you end up back at stock lifts -or worse.
My Base circle grinds lasted less than two years before lift was same as stock.
Properly or not at all....

Righto, that answers that. Cheers

Just found a local crowd that can do the cams for $420 NZD for ground and $900 for a hardface job.

Hmmmmmm

Here's the one on ebay thats been drilled, looks like unlevel drilling? http://www.ebay.co.uk/itm/Honda-VTR1000F-Firestorm-Fork-Yokes-Top-and-Bottom-/161990722044 In the past I had a CBR600 F2 top yoke and they are flat and a bit beefier so could be better to use. Would a Hornet top yoke fit? I wou...

I see you are not using Irridiums, what plug code are you using?

Pon wrote:Here's the one on ebay thats been drilled, looks like unlevel drilling?
http://www.ebay.co.uk/itm/Honda-VTR1000 ... 1990722044

In the past I had a CBR600 F2 top yoke and they are flat and a bit beefier so could be better to use.

Dont care about filtering as I have a B12 for going to work duties. And to those that like the mirror extenders, sorry they are not my thing. But am thinking of a pair of these at 240mm long could work on the fairing. Yes Ive asked if they have all black sets. http://www.trademe.co.nz/Browse/Listing...

Ive got Renthals. At last I can do long rides in comfort.

But the stock mirrors are hopeless. And they are the cause of a lot of noise. Will bar end mirrors look stupid?

still a special looking Storm Jamoi :thumbup: Thanks Paul :) I no longer have a car, so I'm not sure how I'm getting to work tomorrow... :lol: :wtf: :lol: :beer: [/img] Did you get sorted? If I knew before today you could have borrowed my Transalp. Cycled by your gaff on Tues and it looked a bit of...

Pon wrote:

NZSpokes wrote:If you cant afford braided lines, grab some off a hornet 900.

Now that's a good idea, do they have hydraulic clutch too?

No mate they are cable clutch. But the stock line works if you pop it out of its holder by the forks.

Had a wonderful blast up to Dargaville. 370ks of sun and open roads. New top speed for me. Happy days.

If you cant afford braided lines, grab some off a hornet 900.

After reading a bit on Roasty Ducks thread on resistance on plugs I checked one of mine. 3.5kOhm. When hot it drops to 2.5kOhm. I looked at this vid and it says it should be 4k to 8k Ohm. Presume then my plugs are stuffed. Now I dont by any means mind getting new plugs but am interested if this is c...